A worn cleaver blade causes bad cleave angles, lips and chips, and higher splice loss. Learn the warning signs and when to rotate, adjust height or replace the blade on popular cleavers.
Explore the COMWAY C10R for 12- and 16-fiber ribbon projects. Compare its listed cycle times, configuration options, and purchase value with practical advice for buyers considering premium alternatives such as the Fujikura 90R.
An OTDR launch cable box lets you measure the first connector and splice accurately by moving them out of the OTDR dead zone. Learn how it works, 1000m vs 2000m, and how to set it up.
The right OTDR depends on the fiber in the network. Learn how single-mode and multimode OTDRs differ, which wavelengths they use, and when a quad-wavelength model makes sense.
Core alignment splicers align the fiber cores for the lowest loss, while cladding alignment splicers align the outer glass for speed and lower cost. Learn the differences and which type fits your projects.
Thermal strippers remove fiber coatings cleanly without scratching the glass, which is key for strong, low-loss splices. Compare four popular models for single fiber and ribbon fiber work.
G.652D, G.657A and G.654E are the most common single-mode fibers in modern networks. Learn how they differ, where each is used, and how to splice them together with low loss.
A practical guide to choosing the HSV-100D 1625nm configuration for fiber maintenance, including verified functions, connector selection, and checks before active PON testing.
An OTDR trace tells the full story of a fiber link. Learn how to read the slope, identify connectors, splices, bends, ghosts and the fiber end, and avoid common interpretation mistakes.
High splice loss usually traces back to fiber preparation, alignment, arc conditions or testing. Use this 10-point troubleshooting guide to isolate the cause and improve first-pass splice quality.
A practical guide to choosing and using the EXFO MAX-730D-SM8-Oi for single-mode PON and metro networks, with wavelength guidance, iOLM interpretation, test limitations and purchasing questions.
Choosing a fusion splicer for FTTH drops and access networks? We compare four popular models by splice speed, alignment, battery and best use case to help you pick the right one.
